(Also it is in my personal opinion a little bit ridiculous to think if a vendor has a setup that lacking in robustness that a TS setup can offer the complexity to fix this.
And if you have a reboot between Step 2 and 3 the "Last Execution" might be the reboot so it could be that you have to put that stuff in a group. To me it reads as: If it is 0 or 8 reboot if it is 3 reboot as well. That being said as general information I am not sure what to make of those citrix instructions.
Tpo8 task3 code#
You will probably also need to mark the original TS step as "Continue on Error" because I think any return code other than 0 (and maybe 3010) is treated as error and only on a "Run Command Line" step you can specify different allowed return codes. So you can include a step afterwards with a condition based on the value of the TS variable. In general in a TS the return code of the last step is saved in _SMSTSLastActionRetCode ( Task sequence variables documentation) Treat any other return code as an error, and SCCM TASK3 should report an error and end. Restart the machine and repeat SCCM TASK3 until a 0 or 8 is returned. Watch for the return code from the VDA installer.Ġ or 8: Success, installation complete, restart required.ģ: Installation is not complete. (The VDA installer uses the parameters it saved during the first run of the installer.) Resume the VDA installation by running the appropriate VDA installer (XenDesktopVdaSetup.exe for most cases, or XenDesktopRemotePCSetup.exe if VDAWorkstationCoreSetup_XXXX.exe was used) from the location where it was copied (as described in Define the task sequence), with no command-line parameters. Treat any other return code as an error, and SCCM TASK3 should report an error and stop. SCCM TASK3 repeats until the VDA installer returns a 0 or 8 (indicating a successful installation), or 3 (indicating SCCM TASK3 must be repeated). If SCCM TASK2 does not return a 0 or 8, the installation must be continued after the restart completes. If a return code is 3, restart the machine and then pass control to SCCM TASK3. If the return code is 0 or 8, the installation is complete, and a restart is needed. Run the VDA installer of your choice (local image or one of the minimal installers). SCCM TASK1: Prepare the machine by restarting the machine.Īdd the /quiet, /noreboot, and /noresume options to your command line options. The following example shows the installation sequence. "If a return code is 3, restart the machine and then pass control to SCCM TASK3."
Tpo8 task3 how to#
In Microsoft MDT how to I reference another Task Sequence based on the previous Error code?
0 kommentar(er)
